- Correct Assembly Installation
Since hose may change in length from +2% to -4% Under the surge of high
pressure,provide sufficient Slack for expansion and contractionHose should not be twisted.Hose is weakededwheninstalledinbwistedposition
Also Pressure in twisted hose tends to loosen fitting Connections
Design So that machine motion produces bending rather that bwistingNever use a bending radius less than minimum shownin the hose
specilcationthe bending radius of hose should be far away from the
hose fitting (A>1.5R).
Leave proper Length when the hose is connected
Hose bending radius is bigger when it is in motion
Choise proper fittings,avoid too small bending
radius and excess forceChoice proper fittings,avoid twisting in hose lines
bent in two planesChoice proper fittings,avoid excessive hose length
Avoid twisting in hose by using clamp properly
Reduce friction,avoid hose touching the object
directly or far Bway from the object
Correct assembly installation
Model: Correct assembly installation
- You May Also Like